Baseline monitoring reports for industrial users

A. Within one hundred eighty days after the effective date of a categorical pretreatment standard, or the final administrative decision on a category determination under 40 CFR 403.6(a)(4), whichever is later, existing categorical users currently discharging to or scheduled to discharge to the POTW shall submit to the director a report that contains the information listed in subsection B of this section. At least ninety days prior to commencement of the user's discharge, new sources, and sources that become categorical users subsequent to the promulgation of an applicable categorical standard, shall submit to the director a report that contains the information listed in subsection B of this section. The owner or operator of a new source shall report the method of pretreatment it intends to use to meet applicable categorical standards. The owner or operator of a new source shall give estimates of its anticipated flow and quantity of pollutants to be discharged. B. Users described above shall submit the information as follows: 1. Identifying information. The name and address of the facility, including the name of the operator and owner; 2. Environmental permits. A list of all state and federal environmental control permits held by or for the facility; 3. Description of operations. A brief description of the nature, average rate of production, and standard industrial classifications of the operation(s) carried out by such user. This description should include a schematic process diagram that indicates points of discharge to the POTW from the regulated processes; 4. Flow measurement. Information showing the measured average daily and maximum daily flow, in gallons per day, to the POTW from regulated process streams and other streams, as necessary, to allow use of the combined waste stream formula set out in 40 CFR 403.6(e); 5. Measurement of pollutants. a. The categorical pretreatment standards applicable to each regulated process, b. The results of sampling and analysis identifying the nature and concentration, and/or mass, where required by the standard or the director, of regulated pollutants in the discharge from each regulated process. Instantaneous, daily maximum, and long-term average concentrations, or mass, where required, shall be reported. The sample shall be representative of daily operations and shall be analyzed in accordance with procedures set forth in section 14.21A.210 , c. Sampling must be performed in accordance with procedures set forth in section 14.21A.215 ; 6. Certification. A statement, reviewed by the user or its authorized representative and certified by a qualified professional, indicating whether pretreatment standards are being met on a consistent basis, and, if not, whether additional operation and maintenance and/or additional pretreatment is required to meet the pretreatment standards and requirements; 7. Compliance schedule. If additional pretreatment and/or operation and maintenance will be required to meet pretreatment standards, the shortest schedule by which the user will provide such additional pretreatment and/or operation and maintenance. The completion date in this schedule shall not be later than the compliance date established for the applicable pretreatment standard. A compliance schedule pursuant to this section must meet the requirements set forth in section 14.21A.170 ; 8. Signature and certification. All baseline monitoring reports must be signed and certified in accordance with section 14.21A.120 . (Ord. 2760 § 4 (part), 1999)